BBQ grate,stainless wire grill grate,grill grate,stainless steel bbq grate, iron bbq grate, etc. Suitable for indoor and outdoor barbecue, group activities, increase the fun of life.Multi-functional Grill Cooking Grid Grate: This wire mesh is mainly used for BBQ Grill Mat for outdoor cooking, it can also be used as a cooling and baking rack. Or you can develop other uses for it. stainless wire grill grate,stainless steel bbq grate,iron bbq grate,bbq grill grate,bbq grill grates custom Shenzhen Lanejoy Technology Co.,LTD , https://www.wire-spring.com
The construction steps of the project are as follows: a circle of the foundation pit-> excavation of the earth in the foundation pit-> cushion pouring of the base floor cushion layer and the bottom of the beam bottom platform and brick masonry. -> basement floor construction and floor steel reinforcements -> underground outdoor wallboard construction. After the completion of the construction of the underground outdoor wall plate, the construction of the inner and outer wall column structures shall be carried out in a timely manner. After the reinforcement of the outer wall plate, the pre-embedded pipe edge of the installation project shall be reset and installed in time, and then the water-proof bolt shall be used to support the mold and be installed by the sleeve. Cut off the ribs and add reinforcing steel around them. When everything is ready, the concrete is poured and the wall is formed.
After the construction of the basement wall column column, the construction of the top plate shall be carried out in time. After the removal of the wall formwork, the underground exterior wall plate leakage water test shall be conducted in time. When the water is tested, the water pressure will return to the natural floor with no less than 48 hours. Problems are dealt with in a timely manner to ensure that the basement is leak-proof. Wallboard waterproof layer protection layer construction, underground test water after completion of no leakage timely cement mortar screed layer construction training mortar surface stone whitening, timely waterproof layer construction and protective layer construction. Finally, backfill construction is carried out. After the construction of the waterproof layer and protective layer of the external wall is completed, backfill soil construction is carried out in time, and the foundation pit is backfilled with high-quality soil and layered and compacted. Backfill requires no breccia and gravel and is backfilled with high quality clay.
The above is the construction sequence of the waterstop bolts in the basement. It seems to be complicated, but one detail and division of work is done. According to the standard operation, it will be handy and standardization will be completed.
The construction of the sealing bolts in the basement can only be carried out after careful planning. The most important prerequisite is that after choosing a reasonable sealing bolt, all the so-called everything is ready. Only the east wind is owe. Otherwise, the waterproof bolt is less waterproof. The material cannot be started, so it is tedious in the early stage of material selection. No matter what you do, if you do not do thorough accounting and planning, you will not be perfect. The preliminary work of the waterstop bolts was done well, and the back was waiting for the construction.