The Bulls switch is believed to be familiar to everyone and we can often see them in our lives. But does everyone understand how to connect it? How is the Bull Switch wired? So today we'll take a look at the bull switch wiring diagram and hope to help everyone. One, bull switch wiring diagram - bull switch electrician logo The bull five-hole switch, like other brands, has a zero line on the left, a fire line on the right, and a middle ground. The letters on the back are: L FireWire, N Neutral, and Special Marked Ground. The colors of the wires are: the two-color line is the bottom line, the blue line is zero, and any one of red, green, and yellow is the line of fire. Second, the bull switch wiring diagram - bull switch usually connected 1. There are three exposed holes on the bull five-hole switch, which are L fire line, N neutral line, and E ground line. Remove the insulation at 2 cm from the end of the wire and expose the copper wire. 2. Twist the two wires together, extend them into the holes, and install the screws. If the thread is too long, some must be cut. 3. Connect the switch fire wire and the circuit fire wire to the same switch jack. Insert the neutral wire into the N hole and ground wire into the ground wire hole. Third, the bull switch wiring diagram --- Bull switch wiring precautions 1, the switch is the control circuit fire line off, otherwise the appliance will be charged. 2, in the wiring, we must follow the principle of the hue with the cable, with cold-colored line is zero line, the warm color line is the fire line, the color line is the ground line. 3. If the wall junction box is damaged, replace the new junction box in time and fix the junction box with cement and sand. 4. When replacing the junction box, the size must be the same as the original junction box, otherwise, the wall hole should be newly excavated. 5, when replacing the junction box, do not change the junction box at will, so as to avoid the socket can not be connected to the junction box, play a counter-productive effect. Bull switch wiring diagram and how to connect the bull switch the relevant knowledge is introduced here, in fact, the bull five-hole socket wiring method is very simple, as long as the clear zero line, FireWire, ground wire, and then according to wiring standards can be wired. If you want to know about other decoration information, please continue to pay attention to this site, more exciting so stay tuned! Bull switch wiring diagram Zhoushan Jinsheng Bimetallic Plastic Machinery Factory , https://www.jinshenggalloy.com
