If the blind hole thread is to be machined, the selection of the machining center tap is very important. To use the tap of the tail chip, if not, tap the torque handle. When the processing center processing thread parameters are very different, the manufacturer needs to correct the synchronization parameter values ​​and correct the parameters. There is still a little bit of low-diameter tapping to be slightly larger than the standard, so it is better to use, and it will not be easy to break the tap. Led Garden Light,Garden Light Landscape Light,Decorative Garden Light Pole,Garden Light Landscape Lamp Yangzhou Langxu Lighting Technology Co., Ltd , https://www.street-lighting.com
It is easy to tap the tap when tapping the tap with the machining center. It is possible that the type of the tap is wrong, and the imported tap is the best. It is also necessary to check whether the tap parameters used in the machining center are qualified, and then whether the selected cutting fluid is suitable or not, and then tapping in the machining center cannot be used for dry attack. The spindle can not be adjusted to the state of the knife, and it is easy to break the tap. If the material is too hard, it is easy to break. When the machining center taps, it needs to add a little tapping oil. If it is not used vegetable oil.