The material processed by diamond wire cutting is not conductive, so the processing method of wire cutting is adopted. Diamond wire is currently widely used for cutting various metal and non-metal composite materials. Such as ceramics, glass, rocks, gems, jade, meteorites, monocrystalline silicon, silicon carbide, polycrystalline silicon, refractory bricks, epoxy boards, ferrites, PCBs and building materials, dental materials, biological and bionic composite materials, etc., especially suitable for It is suitable for cutting various brittle crystals with high hardness, high value and easily broken.
Diamond Wire,Diamond Wire Saw,Diamond Wire For Crystal,Diamond Coated Wire Jiangyin Baoneng Precision New Material Co.,LTD , https://www.baonengwire.com
If the level of the lowering lever is higher or lower than the horizontal position in the normal state of a gate, if the lowering lever is higher than the horizontal position, first check whether the lower limit switch controlled by the falling lever is loose and loose, then tighten the lower limit screw; Whether the railings are shortened or folded, the length of the tension spring can be adjusted by fine adjustment of the screw sleeve; the leveling machine is re-commissioned to a horizontal position and the screws are tightened. Below the horizontal position, check that the limit switch screw is loose, look at the rails for heavy load, the worm gear of the gate motor wears, the self-locking performance deteriorates, the limit function fails, clean the rail, adjust the screw sleeve, replace the worm, Re-tune the correct position and tighten the screws.
The second gate accepts the signal and cannot normally complete the action. This is often encountered. After the gate accepts the signal, it either does not act, or it cannot reset after the action, and there is a signal to act on it. These are abnormal The barrier lift action. Do a few more trips to the barrage, the signal of the rising bar, the reset signal of the barricade, check the dial switch after the barrage, and reset the dial switch to normal use; check whether the motor is stuck. In case of damage, maintain or replace the motor; check the electrical and electronic components according to Barrier electrical drawings, replace and dispose of the electrical circuit boards, capacitors, and wires that are damaged.
The parking lot system is now a highly intelligent product. The barrier gate is the mechatronics equipment at the heart of the parking lot system. The bearer parking lot controls the movement of the vehicle's entrance and exit lift gates to ensure the normal operation of the parking lot. Since it is an electromechanical device, it will always encounter some faults. The following summarizes the common faults and handling methods used by customers in the use of barriers.