Where to decorate waterproof

It is very important for the renovation and waterproofing project. If you don’t pay attention, you will see leakage and other conditions in the future. Maintenance and troubles will be required. However, the specific place where you need to do waterproofing is not particularly clear. Let's tell you where you need to be waterproof!

1, resurfaced floor tiles

When the kitchen bathroom floor is redecorated, the waterproof layer is most easily damaged. When you specialize in repairing, you should try to protect the original waterproof layer. Once it is destroyed, repair it in time and re-do the waterproof layer. When replacing the floor tiles, after the original floor tiles are gone, they should be smoothed with a cement mortar. Use a waterproof coating, brush, scraper or roller to evenly coat the slurry on the damp base surface to prevent paint leakage and trachoma. The first layer is dried and then the second layer is applied. Pay attention to the slurry during the construction process to maintain intermittent stirring, to prevent precipitation, the slurry should be used within 20-40 minutes.

2. Wall adjacent to bathing equipment

Washbasin, when the sink is in use, water will splash on the adjacent wall. If there is no waterproof protection, the wall will be easily wet and moldy. Therefore, before the tile in front of the shop, be sure to do a good job of waterproofing the wall, but the non-heavy light wall, at least to achieve 1.8 meters high, the best wall waterproof. The waterproof surface of the wall adjacent to the shower position should also be 1.8 meters high. The height of the waterproof coating on the wall adjacent to the bathtub should also be higher than the upper edge of the bathtub.

3, the wall and the ground, the seam between the upper and lower water pipes and the ground

Leakage often occurs in pipes, floor drains, sanitary ware, and yin and yang corners that pass through floors. The reason is that the roots, floor drains and other parts are loose, the adhesion is not solid, the brushing is not strict or the waterproof layer is partially damaged, and the length of the components is not enough. These corners are the most prone to leaks. Attention should be paid to the construction of detailed nodes in weak areas. The waterproof coating must be applied in place. When pipelines, floor drains, etc. cross the floor, the waterproof layer around the hole must be constructed seriously. The upper and lower water pipes shall be cement mulch, brush 10 to 20 centimeters of waterproof paint upwards from the ground, and then make a waterproof layer on the ground to form a composite waterproof layer to enhance waterproof performance.

4, buried water wall

When the water pipe is buried in the wall, the groove larger than the tube should be made. The groove is smooth and smooth. Then, waterproof paint is applied to the groove to perform waterproof treatment.