Solar Light Tower,Solar Light Towers,Portable Solar Light Tower,Solar Traffic Light Tower TIANHEMAST , https://www.robomasts.com
The size of the gap in each part of the cement pad machine
1. The clearance between the scraper and the bottom plate of the cement pad machine feeding mechanism should not exceed 2?.
2. The gap between the underside of the feeding machine and the big plate should be no more than 0.5?.
3. The gap between the adjusting ring and the feeding tray at the upper feeder of the feeder is 0.5-1?.
4. Adjust the height of the track so that after the brick is ejected, the surface of the mold should be higher than the surface of the disk (Answer: The application of thin sheet metal is adjusted on the track and the support surface).
5. Adjust the pain axis of the cement pad mechanism so that it can press out the required pad.
6, adjust the reversing disc mechanism on the rod, gasket and crank mechanism on the axis of the axis of pain to make it active in the empty stroke, the interval is not more than 3?.
7. Condition the adjusting nut on the large-size vertical shaft so that the bottom plane of the bearing plate and the upper plane of the reversing plate should be kept parallel and leave a gap of 1-1.5 mm. Of course, don't forget to try out the machine after the pad machine is commissioned.
After the cement pad machine device is finished, it is necessary to conduct a test run. The test run includes two parts: the blank cut and the load test. Before the test run, the machine shall be inspected for the appearance of the machine, tighten the parts that have not been tightened, remove the debris on the surface of the reversing plate, in the horizontal hole and other transmission components, and add smooth oil to each smooth point, and then manually move the mechanical cement pad. The block machine reversed the reversal plate for 2-3 weeks. After inspecting the padding machine, it confirmed that there was no stuck scene.
The cement pad machine has a fixed range of the gap in each part. When debugging the cement pad machine, it is necessary to pay attention to whether these gaps meet the standard. If the clearance is too small, it may cause friction in various parts of the equipment, which is unfavorable to the equipment and production, and may even damage the equipment. Below Linktech gives the size of the gap in each part.