<<<Links: Construction and Acceptance of Wooden Windows and Doors A. Opening Welding of Angles of Doors and Windows, Breakage of Profiles This kind of problem is mainly caused by the carelessness of the installer during handling, handling, and installation. Therefore, the installation personnel should take care when installing, and do not smash, throw or fall. Beat the door frame and use a plastic hammer to gently knock. Do not use a hammer to knock. After the doors and windows are installed, there is a phenomenon of tilting and sliding of the door leaf. This is mainly due to the fact that the installer did not use the wire during the installation, and checked the verticality between the door and the window and the floor or the table by the ruler, causing excessive deviation. . Therefore, when installing windows and doors, it must be done according to the installation specifications. After the doors and windows are installed, there is a phenomenon of unevenness of the gap between the fan head and the frame, and there is sometimes a problem that the upper width is narrower or the lower width is narrower. To deal with this kind of problem, first measure the level of the window sill or the ground to see which side is high, and then use the high point as a reference. The low place is temporarily fixed with wooden wedges or pads to adjust the level of the window frame. Level adjustment is good, the window will not appear high side and low phenomenon Door and window acceptance window 1220*3050mm Interior Wall Board
Applications
Interior wall and ceiling board
Exterior wall and fencing board
Exterior sheathing
Trim materials
Fascias
Soffits
Shaft-liner and area separation wall board
Tile backing (backer board) and underlayment
Substrates for coatings and insulated systems such as direct-applied finish systems, EIFS, SIPS, Portland type stucco and synthetic stuccos.
Tools and materials you'll need:
Standard screwing drill
Standard health and safety gear
Track saw
Self-drilling, countersunk, slotted-head screws
Hand drill for pre-drilling frame
Standard saw
Retractable knife
Fireproof Wall Board,Fire Resistant Wall Board,Fireproof Ceiling Panels,Fire Rated Fiber Cement Board Shangdong Lanchuang Economy and Trade Co.,Ltd. , https://www.mgoboardsdlceat.com
B. Tilting of doors and windows
C, doors and windows are not horizontal